Start-Up And Use; Switching On The Hob; Switching On The Cooking Zones; Booster Function - Hotpoint CIO 632 CC S Operating Instructions Manual

Start-up and use

!
The glue applied on the gaskets leaves traces of
GB
grease on the glass. Before using the appliance, we
recommend you remove these with a special non-
abrasive cleaning product. During the fi rst few hours of
use there may be a smell of rubber which will disappear
very quickly.
!
A few seconds after the hob is connected to the electricity
supply, a buzzer will sound. The hob may now be switched
on.
Types of noise during normal hob operation:
• Buzz: due to the vibration of the metallic parts that
make up the induction element and the pot; it is
generated by the electromagnetic fi eld required for
heating and increases as the power of the induction
element increases.
• Soft whistle: heard when the pot placed on the
heating zone is empty; the noise disappears once
food or water is placed into the pot.
• Crackle: produced by the vibration of materials on
the bottom of the pot due to the fl ow of parasitic
currents caused by electromagnetic fi elds
(induction); can be more or less intense depending
on the material making up the bottom of the pot, and
decreases as the pot dimensions increase.
• Loud whistle: heard when two induction elements of
the same group function simultaneously at maximum
power and/or when the booster function is set on
the larger element while the other is auto-adjusted.
Noise is reduced by decreasing the power level of
the auto-adjusted induction element; pot bottom
layers made of different kinds of materials are among
the main causes of this noise.
• Fan noise: a fan is necessary to ensure the hob
functions correctly and to safeguard the electronic
unit from possible overheating. The fan functions at
maximum power when the large induction element is
at maximum power or when the booster function is on;
in all other cases, it works at average power depending
on the temperature detected. Furthermore, the fan may
continue to work even after switching the hob off, if the
temperature detected is high.
The types of noise listed above are due to induction
technology and are not necessarily operational faults.
- +
!
If the or button is pressed for an extended
period of time, the display scrolls quickly though the
power levels and timer minutes.

Switching on the hob

To switch the hob on, press and hold the
approximately one second.
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
6

Switching on the cooking zones

Each cooking zone is controlled using a selector button
double
• To begin operating a cooking zone, press the
corresponding control button and set the desired
power level (between 0 and 9) using the buttons
and

Booster function*

The booster function for some of the cooking zones may
be used to shorten heating-up times. It may be activated
by pressing the
above the button will illuminate. This function boosts the
power to 2000 W or 3000 W, depending on the size of
the relevant cooking zone.
The booster stops automatically after 4 minutes. While
the booster for one of the cooking zones is active, the
corresponding front or rear cooking zone will operate
at a reduced power level (e.g. if the booster for the rear
left-hand hotplate has been activated, the power level of
the front left-hand hotplate will be reduced). For further
information, please refer to the Technical description of
the models.
Switching off the cooking zones
To switch off a cooking zone, select it using the
corresponding selector button
• Press the
will progressively decrease until it is switched off.
Programming the cooking duration
! All the cooking zones may be programmed
simultaneously, for a duration between 1 and 99
minutes.
1. Select the cooking zone using the corresponding
selector button.
2. Adjust the power level of the cooking zone.
3. Press the
light corresponding to the selected zone will start
fl ashing.
button for
and a power adjustment device consisting of a
- +
and button.
+
.
Booster
button. The indicator light directly
and:
-
button: the power of the cooking zone
programming button. The indicator
-