Practical advice on using the burners Practical advice on using the electric hotplates Precautions and tips, 9 General safety Disposal Maintenance and care, 10 Switching the appliance off Cleaning the appliance Gas tap maintenance Troubleshooting, 11 7HPC 640 T GH RU/HA...
Installation ! Before operating your new appliance please read this also be equipped with vents to allow gas to escape in the instruction booklet carefully. It contains important information event of a leak. As a result LPG cylinders, whether for safe use, installation and care of the appliance. partially or completely full, must not be installed or stored in rooms or storage areas that are below ground level ! Please keep these operating instructions for future...
Front Connecting the supply cable to the mains Install a standardised plug corresponding to the load indicated on the data plate. The appliance must be directly connected to the mains using an omnipolar circuit-breaker with a minimum contact opening of 3 mm installed between the appliance and the mains. The circuit-breaker must be suitable for the charge indicated and must comply with current electrical regulations (the earthing wire must not be interrupted by the circuit-breaker).
appliance supply ramp and this is fitted with a seal in 3. Having adjusted the flame to the required low setting, order to prevent leaks. The seal must always be replaced while the burner is alight, quickly change the position of after rotating the pipe fitting (seal provided with the knob from minimum to maximum and vice versa appliance).
Description of the appliance Overall view ELECTRIC HOTPLATE * GAS BURNERS Support Grid for COOKWARE Control Knobs for Control Knobs for GAS BURNERS and GAS BURNERS and ELECTRIC HOTPLATES * ELECTRIC HOTPLATES * Indicator Light for Ignition Button for ELECTRIC HOTPLATE * GAS BURNERS * SAFETY DEVICES *...
Start-up and use ! The position of the corresponding gas burner or Electric hotplates* electric hotplate* is shown on every knob. The corresponding knob may be turned clockwise or anti-clockwise and set to six different positions: Gas burners Each burner can be adjusted to one of the following settings using the corresponding control knob: Setting Normal or Fast Plate •...
Practical advice on using the electric hotplates To avoid heat loss and damage to the hotplates, use pans with a flat base, whose diameter is no less than that of the hotplate itself. Setting Setting Cooking vegetables, fish Cooking patatoes (using steam) soups, chickpeas, beans.
Precautions and tips ! This appliance has been designed and • Do not use unstable or deformed pans. manufactured in compliance with international safety • The appliance should not be operated by people standards. The following warnings are provided for (including children) with reduced physical, safety reasons and must be read carefully.
Maintenance and care Gas tap maintenance Switching the appliance off Over time, the taps may become jammed or difficult to Disconnect your appliance from the electricity supply turn. If this happens, the tap must be replaced. before carrying out any work on it. ! This procedure must be performed by a qualified Cleaning the appliance technician authorised by the manufacturer.
Troubleshooting It may happen that the appliance does not function properly or at all. Before calling the service centre for assistance, check if anything can be done. First, check to see that there are no interruptions in the gas and electrical supplies, and, in particular, that the gas valves for the mains are open.