Switching on the cooking zones Booster function Switching off the cooking zones Programming the cooking duration Timer Control panel lock CIO 632 CC Switching off the hob “Demo” mode FLEXI ONE mode Practical advice on using the appliance Safety devices...
Installation Before operating your new appliance please read this instruction booklet carefully. It contains important information concerning the safe operation, installation and maintenance of the appliance. min. 20 mm Please keep these operating instructions for future reference. Pass them on to any new owners of the COMPARTMENT appliance.
Its removal or replacement will void the warranty and Other types of connection the CE marking. INDESIT does not assume liability for accidents or damage arising from replacement/removal of If the mains supply corresponds with one of the following: the original power supply cable.
Description of the appliance Control panel The control panel described in this manual is only a representative example: it may not exactly match the panel on your appliance. TIMER indicator light PROGRAMME TIMER REDUCE TIME display button COOKING ZONE PROGRAMMED FLEXI ZONE BOOSTER indicator light...
Start-up and use Switching on the hob The glue applied on the gaskets leaves traces of grease on the glass. Before using the appliance, we recommend you remove these with a special non-abrasive cleaning product. To switch the hob on, press and hold the button for During the first few hours of use there may be a smell of approximately one second.
3. Confirm by pressing the button. 4. Set the cooking duration using the The timer begins counting down immediately. When buttons. the time has elapsed, a buzzer will sound (for one 5. Confirm by pressing the button or automatic minute). selection occurs after 10 seconds.
The FlexiZONE mode The FLEXI Zone can be used to set the power of two "interconnected" hotplates to the same level. It can be activated if the two hotplates are OFF, by pressing the FLEXI ZONE button The FLEXI ZONE can be activated while the hob is on by pressing the FLEXI ZONE button once;...
Practical advice on using the appliance Overheating protection ! Use cookware made from materials which are If the electronic elements overheat, the hob switches compatible with the induction principle (ferromagnetic off automatically and appears on the display, material). We especially recommend pans made followed by a flashing number.
Precautions and tips This appliance has been designed and manufactured in from the mains socket; do not pull on the cable. compliance with international safety standards. The • Never perform any cleaning or maintenance work without following warnings are provided for safety reasons and must having disconnected the appliance from the electricity be read carefully.
Care and maintenance Switching the appliance off Stainless steel frame (only in models with outer frame) Disconnect your appliance from the electricity supply before carrying out any work on it. Stainless steel can be marked by hard water which has been left on the surface for a long time, or by cleaning products containing phosphorus.
B = booster: the power level of the cooking zone may be boosted to 3000 W * = the maximum power level is limited while the booster is activated for the relevant rear cooking zone (see Start-up and use). CIO 632 CC Hobs Cooking zone...