Jensen VM8113 Installation Manual page 3

Mounting Sleeve Installation
Push the RELEASE button and remove the detachable front
1
panel from the chassis.
Remove the trim ring by fi rmly grasping one side and
2
pulling.
Remove the mounting sleeve.
3
a. Insert the removal keys straight back until they lock. If
removal keys are inserted at an angle, they will not lock
properly to release the unit.
b. Slide the mounting sleeve off the chassis.
Install the mounting sleeve in the dashboard.
4
a. Check the dashboard opening size by sliding the
mounting sleeve into it. If the opening is not large
enough, carefully cut or fi le as necessary until the
sleeve easily slides into the opening. Do not force the
sleeve into the opening or cause it to bend or bow.
b. Locate the series of bend tabs along the top, bottom
and sides of the mounting sleeve. With the sleeve fully
inserted into the dashboard opening, bend as many
of the tabs outward as necessary to fi rmly secure the
sleeve to the dashboard.
Place the radio in front of the dashboard opening so the
5
wiring can be brought through the mounting sleeve.
Follow the wiring diagram carefully and make certain all
6
connections are secure and insulated with crimp connectors
or electrical tape to ensure proper operation.
WARNING! Only connect the unit to a 12-volt power supply
with proper grounding.
After completing the wiring connections, attach the front
7
panel and turn the unit on to confi rm operation (vehicle
ignition switch must be on). If the unit does not operate, recheck all wiring until the problem is corrected.
Once proper operation is achieved, turn the ignition switch off and proceed with fi nal mounting of the
chassis.
Carefully slide the radio into the half-sleeve, making sure it is right-side-up until it is fully seated and the
8
spring clips lock it into place.
Secure the rear of the unit to the car body using the mounting bolt and rubber cushion.
9
Re-attach the decorative trim ring.
10
Re-attach the front panel to the chassis and test radio operation by referring to the operating instructions
11
for the unit.
NOTE: For proper
operation of the CD/
MP3 player, the chas-
sis must be mounted
within 20° of horizon-
tal. Make sure the
unit is mounted within
this limitation.
Steps 8-10
Step 1
Step 3
Step 4b
RADIO
TRIM RING
3
TAB
DASHBOARD
MOUNTING SLEEVE
RUBBER CUSHION
MOUNTING BOLT