Graco SNUGRIDE 30 Instruction Manual page 17

5. Lock the Vehicle
Seat Belt
In most vehicles
today, slowly pull
the shoulder belt all
the way out and then
let it go back in. You
will hear a "clicking"
sound. Slowly pull
out on the belt and it
should be locked. If
not, review your car's
owner manual and
section 6-D.
6. Tighten the
Vehicle Seat Belt
Press down firmly in
the center of the base.
Pull on the shoulder
belt to tighten while
feeding the slack back
in the retractor.
32
7. Test For
Tightness
Grab the sides of the
base where the seat
belt is and push and
pull the base from
side to side and front
to back.
If the base moves
less than 1" (2.5
cm), it is tight
enough.
8. Attach Car Seat
to Base
Place car seat into
the base. Push down
on the front of the car
seat and handle until
you hear a "click".
Test to make sure the
car seat is attached
by pulling up on the
front corners of car
seat.
CLICK!
33