Remove Car Seat From Base; Attach Car Seat To Base; Adjusting Carry Handle - Graco SNUGRIDE 30 Instruction Manual

2-B Remove Car Seat from Base
2-C Attach Car Seat to Base
18
1. To Remove Car
Seat from Base
From the back of the
car seat, squeeze the
base release handle
and lift the car seat
out of the base.
2. Attaching Car
Seat To Base
Align the locking bar at
the front of the car seat
with the locks in the
base. Set car seat in the
base. Push down on
the front of the car seat.
You will hear a "click"
when it is locked.
Pull up on the front
corners of the seat to
make sure it is locked.
2-D Adjusting Carry Handle
1. To Rotate Handle
Press the red handle
adjustment buttons
on both sides of
handle.
MAKE SURE handle
locks into position
before lifting the
carrier.
2. Handle Has 4
Positions
Rotate handle to
any of the 4 locked
positions. Push and
pull the handle to
make sure handle is
in a lock position.
Carry handle MUST
be upright in position
A when carrying.
Handle can be in any
position when used
in the vehicle.
A
B
C
D
19