Operating Instructions - Kärcher G 2600 VH Operator's Manual

CAUTION
Engine shipped without oil. Before starting en-
gine, fill with oil. Do not over-fill. Do not run the en-
gine with a high or low oil level as this can cause
engine damage.
If you have further questions regarding the en-
gine, please refer to the engine manual included
with the unit.
STEP 1:
Check oil level. Oil level should always be be-
tween the "FULL" and "ADD" marks on the
dipstick.
Be sure the machine is level when checking
the oil level. (Refer to the engine's operating
manual for seasonal grades.).
We recommend that the oil be changed after
the first 5 hours of use, then once every 50
hours.
STEP 2:
Fill gas tank with unleaded gasoline.
Do not use leaded gasoline.
Do not add oil to the gasoline.
STEP 3:
Pull back the springloaded collar at the high
pressure outlet and insert the high pressure
hose.
Release the collar and push the high pressure
hose until the collar clicks

OPERATING INSTRUCTIONS

WARNING
High pressure in quick connect area.
Risk of injury caused by improperly locked
high pressure hose.
Make sure you hear a 'click' when inserting
the high pressure hose into the quick connec-
tion.
Pull the high pressure hose to make sure it is
seated properly before operating your unit.
STEP 4:
Connect garden hose to unit's water inlet.
STEP 5:
Connect garden hose to the cold water source
and turn water on completely.
Do not use hot water.
STEP 6:
Unlock the trigger gun safety lock. Trigger the
gun to eliminate trapped air, wait for a steady
flow of water to emerge from the spray nozzle.
STEP 7:
Open fuel valve.
Pull the choke rod to the ON position (on a
warm engine, leave the choke rod in the OFF
position).
STEP 8:
Move the engine stop switch to the ON posi-
tion.
For engine details see engine manual.
STEP 9:
Pull the starter handle.
If the engine fails to start after 3 pulls,
squeeze the trigger gun to release pressure,
and repeat step.
After the engine warms up enough to run
smoothly, move choke rod to OFF position.
9
English