LG 55EC9300 Operating Manual page 34

34
MAGIC REMOTE FUNCTIONS
MAGIC REMOTE FUNCTIONS
When the message Magic Remote battery is low. Change the battery, is displayed, replace the battery. To install \
batteries, open the battery cover, replace batteries (1.5 V AA) matching (_) and (-} ends to the label inside the
\
8
compartment, and close the battery cover. Failure to match the correct polarities of the battery may cause the battery_ .. I y
to burst or leak, resulting in fire, personal injury, or ambient pollution. Be sure to point the remote control at the ___
8
remote control sensor on the TV. To remove the batteries, perform the installation actions in reverse.
[ A CAUTION
Do not mix old and new batteries, as this may damage the remote control.
This remote uses infrared light. When in use, it should be pointed in the direction of the TV's remote sensor.
Q Wheel (OK)
Press the center of the Wheet
button to select a menu.
You can change channels by using
the wheel button.
(BACK)
Returns to the previous screen.
Switches among broadcast (antenna) and
various inputs.
(_)(POWER)
Turns the TV on or off.
_7 <3 D Navigation buttons
(up/down/left!right)
Press the up, down, left or right
button to scroll the menu.
If you press _<(] _:>buttons while
the pointer is in use, the pointer
will disappear from the screen and
Magic Remote will operate like a
general remote control.
To display the pointer on the screen
again, shake Magic Remote to the
left and right.
These access speciai functions in some
menus.
(_ Red, _ Green, _ Yellow, _ Blue)
Adjusts the volume level.
[_
/INPUT
Displays the Screen Remote.
* Accesses the Universal Control Menu in
some regions.
* Pressing and holding the f£2J[3] button
/INPUT
will display a menu to select an external
device that is connected to the TV.
Used for viewing 3D video.
_o (MUTE)
Mutes all sounds.
* By pressing and holding the _o button,
VD function wilt be enabled.
SAP(Secondary Audio Program) Feature can
also be enabled by pressing the _o key.
ACH_
Scrolls through the saved channels.
(Home)
Accesses the Home menu.
@ (Voice recognition)
Network connection is required to
use the voice recognition function.
1. Press the voice recognition button.
2. Speak when the voice display
window appears on the left of the
TV screen.
* Use the Magic Remote no further
than 10 cm (4 inches) from your
face.
* The voice recognition may fail when
you speak too fast or too slowly.
* The recognition rate may vary
depending upon the user's
characteristics (voice, pronunciation,
intonation, and speed) and the
environment (noise and TV volume).