Advertisement
Available languages
Available languages
B@I@S6GÃ
1. Keep work area clean
Cluttered areas and benches can cause
accidents.
2. Consider work area environment
Do not expose the tool to rain. Do not use the tool
in damp or wet conditions. Keep the work area
well lit. Do not use the tool where there
is a risk of causing fire or explosion, e.g. in
the presence of flammable liquids and gases.
3. Keep children away
Do not allow children, visitors or animals to come
near the work area or to touch the tool
or mains cable.
4. Dress properly
Do not wear loose clothing or jewellery, as these
can be caught in moving parts. Preferably wear
rubber gloves and non-slip footwear when
working outdoors. Wear protective hair covering
to keep long hair out of the way.
5. Personal protection
Always use safety glasses. Use a face or dust
mask whenever the operations may produce dust
or flying particles. Wear ear protection whenever
the sound level seems uncomfortable.
6. Guard against electric shock
Prevent body contact with earthed or grounded
surfaces (e.g. pipes, radiators, cookers and
refrigerators). Electric safety can be further
improved by using a high-sensitivity
(30 mA / 30 mS) residual current device (RCD).
7. Do not overreach
Keep proper footing and balance at all times.
8. Stay alert
Watch what you are doing. Use common sense.
Do not operate the tool when you are tired.
9. Secure workpiece
Use clamps or a vice to hold the workpiece.
It is safer and it frees both hands to operate the
tool.
10. Connect dust extraction equipment
If devices are provided for the connection of dust
extraction and collection facilities, ensure that
these are connected and properly used.
11. Remove keys and adjusting wrenches
Always check that keys and adjusting wrenches
are removed from the tool before operating the
tool.
12. Extension cables
Before use, inspect the extension cable and
replace if damaged. When using the tool
outdoors, only use extension cables intended for
outdoor use.
English
13. Use appropriate tool
The intended use is described in this instruction
manual. Do not force small tools or attachments
to do the job of a heavy-duty tool. The tool will do
the job better and safer at the rate for which it
was intended. Do not force the tool.
Warning! The use of any accessory or
attachment or performance of any operation with
this tool other than those recommended in this
instruction manual may present a risk of personal
injury.
14. Check for damaged parts
Before use, carefully check the tool and mains
cable for damage. Check for misalignment and
seizure of moving parts, breakage of parts,
damage to guards and switches and any other
conditions that may affect its operation.
Ensure that the tool will operate properly and
perform its intended function. Do not use the tool
if any part is damaged or defective. Do not use
the tool if the switch does not turn it on and off.
Have any damaged or defective parts repaired or
replaced by an authorised repair agent. Never
attempt any repairs yourself.
15. Unplug the tool
Unplug the tool when it is not in use, before
changing any parts of the tool, accessories or
attachments and before servicing.
16. Avoid unintentional starting
Do not carry the tool with a finger on the on/off
switch. Be sure that the tool is switched off when
plugging in.
17. Do not abuse cord
Never carry the tool by its cord or pull it to
disconnect from the socket. Keep the cord away
from heat, oil and sharp edges.
18. Store idle tools
When not in use, tools should be stored in
a dry, locked up or high place, out of reach of
children.
19. Maintain tools with care
Keep cutting tools sharp and clean for better and
safer performance. Follow the instructions for
maintenance and changing accessories. Keep
handles and switches dry, clean and free from oil
and grease.
20. Repairs
This tool complies with relevant safety
requirements. Repairs should only be carried out
by qualified persons using original spare parts;
otherwise this may result in considerable danger
to the user.
8
Advertisement
