Operation; Tips - Montarbo Duetto Light 8 User Manual

oPeRAtIons
In order to avoid unpleasant and dangerous noises, please turn on your dueTTo lIGHT amplifier last, after turning on
all the instruments, sources and mixer. at the end of the gig, please turn off your dueTTo lIGHT amplifier first, before
any other equipment.
In case of three (or more) dueTTo lIGHT daisy-chaining, please connect first (in alphabetical and connection order) the
amplifier output to unit "a", then from "a" to "B" and finally "B" to unit "C". after your session the unit you've to
disconnect first is the "C" unit, then "B" unit and finally "a" unit.
Before any installation, please check that dueTTo lIGHT amplifier(s) level knobs are set at minimum. If an amplifier level
is raised, please move it to its lower position, preventing in this way any noise which could damage your speakers.
Using power cable of the right size connect the amplifier outputs to dueTTo lIGHT 6.35 mm (¼") and 4-pole speakOn
In. in case of daisy-chaining connect the lInK connector of first speaker to In connector of second speaker, and so on.
Cables provided with 6.35 mm (¼") are less expensive than cables equipped with SpeakOn, which ensure a more reliable
connection and accept large size cables, allowing your cable to accept your amplifier full power! For these reasons we
suggest to purchase cables with speakOn

tIPs

The plastic cabinet is provided of built-in heavy-duty transportation handle. Use this handle for secure and easy transportation,
not for suspending your loudspeakers.
The choice of the amplifier must be based on dueTTo lIGHT power rating. For example, in case of a stereo amplifier feeding
two dueTTo lIGHT 8 the amplifier power should be 100 W. We strongly suggest to don't use a less powerful amplifier!
In case of a more powerful amplifier be careful with level knobs settings. The same principle must be used daisy-chaining
four dueTTo lIGHT 8 (two for each side) – then amplifier must be rated @ 200 W.
In order to avoid overload, please carefully check the overall sound; hearing even a small saturation, please turn counter-
clockwise the mixer or amplifier knob, or the level knob of the source which is distorting. In order to prevent speakers
switch-on thump, please turn the amplifier level knob to its minimum position after every session, and check the amplifier
knob at its minimum position before starting any new session. We strongly suggest you to avoid exposition to loud music
for prolonged periods, you risk to seriously damage your hearing.
DUetto LIGHt seRIes – Rigging and mounting options
360°
360° - turnable logo faceplate
connectors.
®
Floor Monitor Brackets
These brackets are help ful for DJ's and bands to help monitor their sound during
a performance. This is also an alternative to standing the speaker straight up
or mounting it on a stand. These brackets slide into each end of the speaker.
Each speaker has its own special sized floor bracket.
DUETTO LIGHT SERIES Passive Full Range loudspeakers | Owner's manual
®
5