Command Control; Pjlink™ Protocol - Panasonic TH-42LF6W Operating Instructions Manual

Using Network Function

Command Control

Network function of the unit can control the unit in the same way as serial control from a network GXULQJ SRZHU ³2Q´.
Supported commands
Commands used in the serial control are supported. (see page 17)
Note:
‡ Consult your local Panasonic dealer for detail instructions on command usage.
PJLink™ Protocol
The network function of the unit conforms with PJLink class 1 and you can operate the following actions from your
computer using PJLink protocol GXULQJ SRZHU ³2Q´.
‡ Display setup
‡ Display status query
Supported commands
Commands to control the unit with PJLink™ protocol are shown in the table below.
Command Control
POWR Power control
POWR ? Power status query
INPT Input switch
INPT ? Input switch query
AVMT Shutter control
AVMT ? Shutter control query
ERST ? Error status query
LAMP ? Lamp status query
INST ? Input switch list query
NAME ? Projector name query
INF1 ? Manufacturer name query
INF2 ? Model name query
INFO ? Other information query
CLSS ? Class information query
PJLink™ security authentication
Set "panasonic" for the PJLink™ password.
‡ PJLink™ is a pending trademark in Japan, the United States, and other countries or areas.
)RU VSHFL¿FDWLRQV UHJDUGLQJ 3-/LQNŒ UHIHU WR WKH -DSDQ %XVLQHVV 0DFKLQH DQG ,QIRUPDWLRQ 6\VWHP ,QGXVWULHV
Association website.
http://pjlink.jbmia.or.jp/
56
Parameter
0 = Standby
Parameter
1 = Power "On"
Parameter
See the parameter for command INST ?
Parameter
10 = Picture On (picture mute deactivated), 11 = Picture Off (picture on mute)
20 = Audio On (audio mute deactivated), 21 = Audio Off (audio on mute)
30 = Shutter mode Off (picture and audio mute deactivated)
31 = Shutter mode On (picture and audio on mute)
Parameter
11 = Picture Off (picture on mute)
21 = Audio Off (audio on mute)
30 = Shutter mode Off (picture and audio mute deactivated)
31 = Shutter mode On (picture and audio on mute)
Parameter
First byte: 0
Second byte: 0
Third byte: 0
Fourth byte: 0
Fifth byte: 0
6L[WK E\WH 0HDQV RWKHU HUURU  RU 
Meaning of the 0 – 2 settings:
0 = Error is not detected, 2 = Error
Not supported
Parameter
11: PC IN input (PC)
21: VIDEO IN input (VIDEO)
22: COMPONENT/RGB IN input
(Component)
31: HDMI1 input (HDMI1)
Return the Display name contents selected in "Network Setup".
Returns "Panasonic"
Returns "47LF6W" (For 47-inch LF6 model)
Returns version number
Returns "1"
Remark
32: HDMI2 input (HDMI2)
33: DVI -D IN input (DVI)
34: ',*,7$/ /,1. LQSXW ',*,7$/
/,1.