Saw Chain Filing And File Gauges - Husqvarna 385XP Operator's Manual

Recommended cutting equipment for Canada
The following cutting attachments are approved for the models Husqvarna 385XP, 385XPG, 390XP and 390XPG. The
combinations of powerhead, bar and chain meet all requirements outlined in the CSA Z62.1-03 Chainsaws and Z62.3-
04 Chainsaw Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent
or less kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which
are available at your dealer.
Bar
Length, inch Pitch, inch
18-28 3/8"
18-28 3/8"
Listed ATM is the Oregon designation of Armour Tip Medium hard nose bar.
Note: For the chains above you are free to choose between 0,050" and 0,058" gauge drive link for the corresponding
bar, see the table below.
0,050"/1,3 mm
0,058"/1,5 mm
WARNING! This chain saw model is capable of severe kickback that could result in serious injuries
!
to the user. Do not operate this saw unless you have extraordinary cutting needs and experience
and specialized training for dealing with kickback. Saws with significantly reduced kickback
potential are available. Always use the safest saw and cutting equipment applicable to your cutting
need.
Saw chain filing and file gauges
40 – English
TECHNICAL DATA
Gauge, inch
0,058
0,058
- 72LP 72LG
H42 73LP 73LG
Chain
Max. nose radius Type
11T Husqvarna H42,
Oregon 73LP / 73LG
ATM 1,33"
/ 73V
72V
73V
Drive link count
68-92
68-92