Advertisement
Make sure that the pointer points to 0"
I
I
I I
I
Carefully square the side of the blade
with the top surface of the turn base
on the miter scale. .If the pointer does
not point to
0",
loosen the screw which
secures the pointer and adjust the point-
er so that it will point to 0".
Triangular rule
I
2) Bevel angle
i) 0" bevel angle
Push the carriage toward the guide
fence and tighten the clamp screw to
secure the carriage. Lower the handle
fully and lock
it
in the lowered position
by pushing in the lock pin. Loosen the
lever at the rear of the tool. Turn the
0" bevel angle adjusting bolt (lower
bolt) on the right side of the arm two
or three revolutions counterclockwise
to tilt the blade to the right.
Miter.scale
Pointer
0"
bevel angle
adjusting bolt
using the triangular rule, try square,
etc. by turning the 0" bevel angle
adjusting bolt clockwise. Then tighten
the lever securely.
of
turn base
26
Advertisement
