Preventing Unauthorized Access; Setting The Prohibit Setting; Setting Can Be Made Only From The Control Panel - Konica Minolta nizhub c250p User Manual

2
2.3

Preventing Unauthorized Access

When access to the Admin. Setting mode by the Administrator of the ma-
chine via the control panel is authenticated, the machine takes a count of the
number of unsuccessful accesses to the Admin. Setting mode, SNMP au-
thentication, Secure Print authentication, and User Box authentication. It
also enables setting of the operation of the Prohibit Setting that prohibits the
authentication operation.
Either "Mode 1" or "Mode 2" can be selected for Prohibit Setting. The factory
setting is "Mode 1." If the EnhancedSecurity mode is set to "ON," it is pro-
hibited to change the setting from "Mode 2" (check count: three times). It is
nonetheless possible to change the check count to select from among once,
twice, or three times. For details of each mode, see the table below.
Mode
Mode 1
Mode 2
2.3.1

Setting the Prohibit Setting

Note
Do not leave the machine with the Admin. Setting mode setting screen
left shown on the display. If it is absolutely necessary to leave the ma-
chine, be sure first to log off from the Admin. Setting mode.
<Setting can be made only from the control panel>
0 For the procedure to call the Security Setting screen to the display, see
steps 1 and 2 of "Setting the EnhancedSecurity mode" on page 2-10.
1
Call the "Security Setting" to the screen from the control panel.
2
Press the [
2-14
Description
If authentication fails, the authentication operation (entry of the password)
is prohibited for 5 sec.
If authentication fails, the authentication operation (entry of the password)
is prohibited for 5 sec. The number of times, in which authentication fails,
is also counted and, when the failure count reaches a predetermined val-
ue, the authentication operation is prohibited and the machine is set into
an access lock state.
)
] key.
Administrator Operations
C250P