Advertisement
Adjusting the depth of cut
Loosen the screw on the depth guide and move the base up or down. You can read the
depth
of
cut by aligning the top of the notch in the depth guide with the graduations on its
right side. (Note: This can be done for 0" bevel cutting only.) At the desired depth of cut,
secure the base by tightening the screw
Depth guide
F r - -
CAUTIO N
:
Depth guide
Top of notch
*Use a shallow depth of cut when cutting thin workpiece for cleaner, safer cuts
*After adjusting the depth of cut, always tighten the clamp screw securely.
Bevel cutting
Loosen the screw on the bevel scale plate
on the front of the base. Set for the desired
angle (0"
- 45")
by tilting accordingly, then
tighten the clamp screw securely.
Screw
I I
Bevel scale plate
CAUTION:
After adjusting the depth of cut and bevel cutting angle, be sure to tighten the screw.
14
Advertisement
