Disassembling The Machine's Internal Parts - Jede QUATTRO Service Manual

QUATTRO

6.5 Disassembling the machine's internal parts

1. Open then lift the front of the machine and push it
backward.
2. Remove the drink cartridges. Note their placement.
3. Remove the two funnels (2, figure 16) by pulling
them straight out.
4. Remove the dispenser (figure 17) by pressing in the
catch (1), then lift the dispenser upward and then
straight out (2).
5. Remove the hoses (8, figure 16) from mixer bowls
(7, figure 16).
6. Remove the mixer bowls by turning the lock ring
counter clockwise (figure 18).
7. Remove the whipper (12, figure 16) by pulling it
outward.
8. Remove the lock ring (figure 18) by turning it coun
ter clockwise to stop and then pull it outward parallel
to the whipper shaft.
9. Pull out the fan duct (3, 5, figure 16) and open its
two halves. Remove the filter (4).
10. Remove the spill tray (11, figure 16) and its grate
(10).
Wash all of the parts in warm water. Be careful to dry all the parts before they
are re-mounted as moisture has a negative effect on the machine's function. Put
the parts back together in reverse order as per the above.
Figure 19
7
Service manual
Ensure that the marking dot on the whipper
is aligned with the flat edge on the whipper
shaft. (figure 19), then press firmly until it
clips fully in place.
1
2
Figure 17
Figure 18
Rev. A
2012-09-10