Canon CanoScan 5600F Quick Start Manual page 10

35 mm Slides
Push the Film Holder on the Film Guide inward to
open it in order (1) and (2) as shown in the figure on
the right. With the Film Holder being opened and
lifted, remove the film strip frame.
Align the Film Guide's tab with the FILM symbol on
the document glass of the scanner.
Place a slide or slides face down (correctly viewed
from below) in the Film Guide as shown in the figure
on the right.
How to put the film strip frame after slide scanning is done
(A) Align the marks on the film strip frame and the
marks on the Film Guide, and then insert each
tab on the top of the film strip frame into the Film
Guide.
(B) Push the edges of the Film Holder inward with your
fingers to close it firmly.
If the Film Holder does not fit into the Film Guide, press down the whole of it.
3
Close the document cover.
4
Start MP Navigator EX.
Follow the step 2 in "Try Scanning" on page 5.
(1)
(2)
Calibration Slot
(A)
(B)
Scanning Film
9