Be sure to install the software programs before connecting the scanner to the computer! Please read this guide before operating this scanner. After you finish reading this guide, store it in a safe place for future reference. Setup and Scanning...
Adobe Acrobat Reader should be installed on your computer. The socket-outlet shall be installed near the equipment and shall be easily accessible. Use of a shielded cable with the ferrite core(s) provided with the scanner is necessary to comply with the technical requirements of the EMC Directive.
It also works with the scanner buttons. ArcSoft PhotoStudio (35 MB / 20 MB) - Image Editing Program It allows you to load images from the scanner, edit and retouch them, and apply special effects and enhancements. ScanSoft OmniPage SE (90 MB / 80 MB) - OCR (Optical Character Recognition) Program It converts characters scanned from a book, magazine or newspaper into text data for editing or digital transmission.
Install the Software (Windows) Install the Software • With Windows XP/2000, you should log on with an administrator user name when you install or uninstall software programs. • If you are using a computer which does not equip USB 2.0 interface by standard, refer to P.
Install the Software Turn the computer on. Make sure to log in with the first created administrator to install the software. You cannot install the software when logged in using added administrator accounts. Place the CanoScan Setup Utility CD-ROM in the drive.
• Do not tilt the scanner more than 90 degrees from horizontal when releasing the lock. • When locking the scanner, do not lift up the back and tilt the front (scanner button location) downward. You may be unable to set the lock.
• The scanner does not have a power switch. The power is activated as soon as the computer is turned on. • When the scanner is connected to the USB 1.1 port on Windows XP, do not worry if the "HI-SPEED USB Device Plugged into non-HI-SPEED USB Hub" message appears. You can operate the scanner in this condition without problems.
Try Scanning Try Scanning The following steps explain how to scan with ArcSoft PhotoStudio. Place a photo or a picture on the glass by aligning its top edge with the alignment mark, and close the document cover. Windows Select [Start], [Programs] or [All Programs], [ArcSoft PhotoStudio 5.5] and [PhotoStudio 5.5].
Click the [File] menu and choose [Select Source]. Select your scanner model name and click the [Select] button for Windows or the [OK] button for Macintosh. • After you set this setting the first time, you do not need to set it from the second time onward with the same scanner.
(Windows) or the PhotoStudio window to close it. • If the scanner does not perform as described above, read the "Troubleshooting" section of the Scanning Guide (HTML format manual). • For details about the bundled software programs, read the Scanning Guide or the User’s Guide (PDF format manual) for each software program on the CanoScan Setup Utility CD-ROM.
Using the Scanner Buttons You can use the four convenient buttons on the front of the scanner to scan and perform related tasks easily with a single touch of the button. Place an item on the scanner before pressing a button.
Macintosh computer with USB 2.0 Hi-Speed interface expansion card is not supported. Compatible USB Expansion Cards/Hubs Please use one the following USB expansion cards/hubs that have been verified by Canon for compatibility. Expansion Cards • Adaptec USB2connect 5100: PCI bus •...
• Before you upgrade to Windows XP from Windows 98/Me/2000, you must uninstall ScanGear CS and CanoScan Toolbox using the “Uninstall the Software” menu of the CanoScan Setup Utility CD-ROM. The scanner may not work if you upgrade to Windows XP with these programs still installed. After upgrading to Windows XP, reinstall ScanGear CS and CanoScan Toolbox according to the steps on page 4.
This form should be used to record the operating environment for the purchased scanner. If any problems occur with the scanner, you will need this information when you contact our Customer Support Help Desk. Be sure to record the information and store it in a safe location.