Advertisement
Switch action
o s e t
the reversing switch lever just in front
of the trigger switch to Forward (FWD)
or Reverse (REV). Then pull the trigger
to turn the tool ON and release it to turn
it
OFF. To change the direction of bit
rotation, release the trigger,
let
the tool
come to
a
complete stop, and then slide
the switch lever to the opposite side. The
trigger switch does not work if the switch
lever is in the neutral position.
CAUTl ONS:
0
Before inserting the battery cartridge into the tool, always check to
see
that the trigger
0
When not operating the tool, keep the lever switch in the neutral position.
0
Before operation, always check to be sure that the switch lever is set for the desired
0
Pulling the trigger hard when the lever switch i s set to neutral can cause a switch break-
switch actuates properly and returns to the "OFF" position when released.
direction of rotation.
age.
Holding tool
.When pushing down on the front of the tool, be careful not to touch the drill chuck or
bit with your fingers or the palm of your hand.
Drilling in
metal
.Punch a small hole in the metal t o pre-
vent the bit from skitterring when start-
ing to drill a hole.
8
Advertisement
