GE FHSD720C Installation And User Manual page 36

FHSD700C Series Product Guide
5.3.9 LASER CAL: Laser Calibration
Minimum Access Code Required: Level 3
This menu option is only available for factory use to calibrate the laser.
5.3.10 LOAD DEFAULTS: Load Defaults
Minimum Access Code Required: Level 2
This menu option will enable the user to reload all factory defaults for all configuration parameters under
the Configuration and Sector Alarms menus. It is recommended that the system configuration is saved
prior to applying this menu option.
5.3.11 MAINTENANCE: Maintenance Mode
Minimum Access Code Required: None
Use the Parameter UP & DOWN buttons (Isolate and Scan) to inspect any item in the maintenance list.
LASERIN
MOD1 IN
MOD2 IN
MOD3 IN
MOD4 IN
MOD5 IN
5.3.12 TEST OUTPUTS: Testing Mode
Minimum Access Code Required: Level 2
This menu item enables the user to manually increase or decrease smoke levels for the detector in
order to simulate a real fire event. This enables the user to test the responses of the detector to a fire
event. Please note that all alarms and relays will operate as if the system is reacting to a real fire event.
30
Table 5-8: Maintenance Parameters
Parameter
Current smoke value for the laser detector output
Identification number of Module 1
Identification number of Module 2
Identification number of Module 3
Identification number of Module 4
Identification number of Module 5
Description
GE Security
www.gesecurity.net