GE FHSD720C Installation And User Manual page 28

FHSD700C Series Product Guide
OPCODE Operator Function Access Code
ENDSCTR End Sector (number of sectors used)
DENSLOG Log of density change
F2LTCH Fire 2 Latch
F1LTCH Fire 1 Latch
ACTLTCH Action Latch
ALTLTCH Alert Latch
TRCLTCH Trace Latch
FLTLTCH Fault Latch
TRCRLY Trace Relay 1
REFCOMP Reference Compensation
REFDEL Reference Delay
FLOWDEL Flow Fault Delay
FLOWHI Flow High Limit
FLOWLO Flow Low Limit
FLOWLOG Log of flow change
SETFAN Set Fan Speed
STANDBY Battery Charger Enable
PWRDEL AC power supply fail delay
BUZZER Internal Sounder Enable
BEACON Beacon Enable
ADDRESS RS485 Address
TESTTIM Time between automatic scans
Note: TESTIM is also used for FHSD700C-15 Flow normalization by
pressing ENTER
MIN DWELL Rotary valve dwell time
GAIN X See description
MOD1 Set Module 1 usage
MOD2 Set Module 2 usage
MOD3 Set Module 3 usage
MOD4 Set Module 4 usage
MOD5 Set Module 5 usage
SC DEL Suppression Control Delay
NIGHSTART Night Start time (Hour in 24 format)
NIGHSTOP Night Stop time (Hour in 24 format)
TRC PRESS Setup for auto Valve Scan
Note: Avoid setting to values already defined for Level 1 or 2 Access Codes.
Note: When Standby is set to 1, the panel display will switch off if the AC mains supply is removed.
Note: To revert all Configuration parameters to their default values go to the LOAD DEFAULTS menu
item and press ENTER (Level 2 Access Code is required). The Unit will restart with default
parameters.
22
Table 5-4: Configuration Mode Parameters and Values
Parameter
GE Security
Range Factory
Default
0 to 999 0
1 - default 4, 6, 8 or 15
0.01 to 20.00 0.02
0 or 1 1
0 or 1 1
0 or 1 1
0 or 1 1
0 or 1 1
0 or 1 1
0 or 1 0
0 to 5% 2.00%
5 to 60s 15s
1 to 60s 5s
105 to 200% 120%
0 to 95% 80%
0.0 to 200.0 5.0
3 to 10 5
0 or 1 0
1 to 1000s 10s
0 or 1 1
0 or 1 1
0 to 30 31 (off)
0 to 30 mins 20
0 to 60s 0s
0 to 120 60
12 to 23 12
0 to 12 12
5 to 1000 25
www.gesecurity.net