Scheduled Inspection Report; Recommended Overhaul And Replacement Times; Special Inspections; 800 Hour Progressive Inspection Program - Cirrus SR22 Maintenance Manual

C I R R U S
A I R P L A N E M A I N T E N A N C E M A N U A L

3. SCHEDULED INSPECTION REPORT

All references to "5-20" under the "ATA Ref" reference column are to be understood as reference to Visual
Inspection criteria defined under Inspection Groups and Criteria.
A. Recommended Overhaul and Replacement Times
Recommended overhaul and replacement times are listed in Section 5-10, Time Limits. These mainte-
nance items must be incorporated into the 100 Hour, Annual, or Progressive inspections as applicable.
(Refer to 05-10)
B. Special Inspections
Special Inspections are denoted with a bracketed asterisk [
• Special Inspections beginning with the word "And" indicate the examination is in addition to the
regularly scheduled interval. For example the following inspection states that in addition to chang-
ing engine oil every 50 Hours, Annually (or every 100 Hours if aircraft flown for hire), and at each
Progressive Phase Interval, the oil should be change after the first 25 hours of operation
Select Inspection Program ------------->>>
6. Engine Oil
Drain and change oil.
*Special Inspection:
• Special inspections beginning with "Only" require examination only at the specified time interval.
For example, the following inspection states that Inspection/Check - Cabin Air Control Assembly
should only be performed every 500 hours or every 5 years, whichever occurs first.
Select Inspection Program ------------->>>
24. Cabin Air Control Assembly - Serials 22-
2438 & subs w/o Perspective Avionics
Perform Inspection/Check - Cabin Air Con-
trol Assembly
*Special Inspection:
or 5 years whichever first.
C. 800 Hour Progressive Inspection Program
In addition to the Progressive Phase Inspections I, II, III, IV, V, the program uses an alternating 50 Hour
oil service and general aircraft inspection as specified under the Traditional Program's 50 Hr column.
Phase Inspection columns annotated with a bracketed 800, e.g. [
that apply only to the 800 Hour Progressive Inspection Program. Operators enrolled under the 800
Hour Program are encouraged to provide Cirrus Design with maintenance feedback on these supple-
mental inspections using the online Publication Change Request form.
http://servicecenters.cirrusdesign.com/TechPubs/serviceloopform.asp
EFFECTIVITY:
All
Engine Group
And first 25 hours
Cabin Group
Only every 500 hours
M O D E L S S R 2 2 A N D S R 2 2 T
* ].
Traditional
Program Inspection Phase
ATA 50 Annual/
I
Ref Hr 100 Hr
12-10 [ * ] [ ] [ ] [ ] [ ] [ ] [ ]
Traditional
Program Inspection Phase
ATA 50 Annual/
I
Ref Hr 100 Hr
21-60 [ * ]
800
], are supplemental inspections
.
Progressive
II III IV V
Progressive
II III IV V
[ * ]
05-20
Page 3
15 Dec 2014