Brother DCP?1618W Quick Setup Manual

DCP‑1618W / MFC‑1919NW
Quick Setup Guide
Version 0
CHN‑ENG
Unpack the machine and check the components
Inbox Toner Cartridge
Quick Setup Guide,
Product Safety Guide and
Basic User's Guide
1
Remove the packing materials and install the toner cartridge
2

Load paper in the paper tray

3
Connect the power cord and turn on the machine
Back
5 Configure the machine for faxing (for MFC‑1919NW)
If you do not plan to use the fax feature on this machine, go to step 6.
NOTE:
• To complete fax setup on your machine, see the Basic User's Guide.
• Your machine is programmed to automatically receive faxes. To change this default mode, see the Basic User's Guide.
A. Connect the telephone line cord
6
Connect the machine to your computer/mobile device
• Windows PC with a CD‑ROM drive, go to step
®
• Windows PC without a CD‑ROM drive, go to step
®
• Macintosh, go to step 6B
• Mobile device users with a WPS/AOSS™‑supported access point/router, go to step
Telephone Line Cord
(For MFC‑1919NW)
A5 Long Edge Paper Input
CD‑ROM
Support
To use A5 Long Edge paper.
Front
B. Set the date and time
Date
1.
Press Menu, 0, 1, 1.
2.
Enter the last two digits for the year on the dial pad,
and then press OK.
3.
Enter the two digits for the month on the dial pad, and
then press OK.
4.
Enter the two digits for the day on the dial pad, and
then press OK.
6A
6B
The latest manuals are available at the Brother
Solutions Center: solutions.brother.com/manuals.
Read the Product Safety Guide first, then read this Quick Setup Guide for the
correct installation procedure.
NOTE:
• The illustrations in this Quick Setup Guide are based on the MFC‑1919NW.
(For MFC‑1919NW) • You must purchase the correct interface cable for the interface you want to use.
USB cable
We recommend using a USB 2.0 cable (Type A/B) that is no more than
2 metres long.
Network cable
Use a straight‑through Category 5 (or greater) twisted‑pair cable for 10BASE‑T
or 100BASE‑TX Fast Ethernet Network.
USB Interface Cable
Adjust the paper guides to fit
the paper being used.
Change your language (if needed)
4
Only for certain models
1.
(DCP models)
1. Press Menu, and then press ▲ or ▼ to choose 1.General Setup.
2. Press OK.
(MFC models) Press Menu, 0, 0, and go to step 3.
2.
Press ▲ or ▼ to choose 0.Local Language, and then press OK.
3.
Press ▲ or ▼ to select your language, and then press OK.
4.
Press Stop/Exit.
Time
1.
2.
6C
Enter the time using the dial pad, and then press OK.
Press Stop/Exit.