Advertisement
Adjusting saw chain tension
CAUTION
:
Always be sure that the tool is switched off and unplugged before adjusting chain tension.
Grasp the chain in the middle of the guide
bar and lift up. The gap between the side
link of the chain and the guide bar should
be about 3 mm to 4 mm
(1/8"
-
5/32").
Fig. 5
I f the gap is not about 3 m m to 4 m m
(1/8"
-
5/32"), adjust the chain tension.
Use
a
screwdriver to turn the chain tension
adjusting screw clockwise for more tension,
or counterclockwise for less tension. When
adjusting the chain tension, lift the end of
the guide bar slightly.
Fig. 6
After adjusting the chain tension, use the
socket wrench to tighten the hex bolt
securely.
CAUTION
:
When breaking in
a
new chain, adjust the ten
I
Fig.
7
ision often, since
it
tends to 'stretch'.
9
Advertisement
