Maintenance - Black & Decker Alligator GK1000 User Manual

Switching on and off
Warning! Never attempt to lock or fix a switch actuator in the
on position.
For your safety, this tool is equipped with a double switching
system. This system prevents starting the tool inadvertently.
Switching on (fig. F)
Ensure a firm grip on the handles and then squeeze

both switch actuators (5) to switch the unit on.
Switching off (fig.F)
Release either of the switch actuators (5).
Note: Both switch actuators must be activated for the
product to be used.
Do not force the tool, allow it to do the work. It will do a better
and safer job at the speed for which it is designed. Excessive
force will stretch the chain.
If the saw chain or chain guide bar (3) becomes jammed:
Switch the tool off.

Disconnect the tool from the mains supply.

Open the cut with wedges to relieve the strain on the

chain guide bar (3). Do not try to wrench the saw free.
Start a fresh cut.
Trimming branches (fig. G)
Ensure that there are no local by-laws or regulations that
would prohibit or control the trimming of the tree limbs.
Make sure the tool is running at full speed before making a
cut.
Hold the tool firmly in place to avoid possible bouncing

or sideways movement of the tool.
Guide the tool using light pressure.

Always cut down from the top. This way you will avoid
pinching the saw chain.
Remove branches as shown in fig G, starting from the

branch tip, reduce the branch in logical steps cutting off
small sections.
Remove the tool from the cut while it is running at full

speed.

Maintenance

Your Black & Decker corded/cordless appliance/tool has
been designed to operate over a long period of time with a
minimum of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Warning! Before performing any maintenance on corded/
cordless power tools:
Switch off and unplug the appliance/tool.

Or switch off and remove the battery from the appliance/

tool if the appliance/tool has a separate battery pack.
Or run the battery down completely if it is integral and

then switch off.
Unplug the charger before cleaning it. Your charger

does not require any maintenance apart from regular
cleaning.
Regularly clean the ventilation slots in your appliance/tool/
charger using a soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth. Do
not use any abrasive or solvent-based cleaner.
Regularly open the chuck and tap it to remove any dust from
the interior (when fitted).
Cleaning
Regularly remove the chain access cover and remove

any debris that has become trapped.
Regularly clean the ventilation slots with a clean, dry

paint brush.
To clean the tool, use only mild soap and a damp cloth.

Never let any liquid get inside the tool and never
immerse any part of the tool into liquid.
Oiling
Regularly oil the oiling points (10) as indicated in fig. B.

Transport
Always transport the tool with the jaws closed.

Storage
When the tool will not be used for several months, wipe

any metal components with oil.
Store the tool in a secure and dry location. The storage

temperature must always remain in the range of + 5 °C
to + 40 °C. Place the product on a level safe location.
Mains plug replacement (U.K. & Ireland only)
If a new mains plug needs to be fitted:
Safely dispose of the old plug.

Connect the brown lead to the live terminal in the new

plug.
Connect the blue lead to the neutral terminal.

Warning! No connection is to be made to the earth terminal.
Follow the fitting instructions supplied with good quality
plugs. Recommended fuse: 5 A.
11