Table of Contents
Advertisement
Putting the EKI 830 into operation
Setting the receiver to the frequency of the transmission system
The receiver allows you to select between three channels with preset
frequencies so that you can match the receiver to the channel used by
your transmission system.
Overview of the channel indicator:
Channel
Channel
indicator
1
2
3
To change the channel:
If you wish your Sennheiser partner can permanently assign the
receivers to either channel 1 or 2 and disable the channel selec-
tion button to prevent user tampering.
Frequency
2.3 MHz
2.8 MHz
2.3 MHz + 2.8 MHz stereo
Press the on/off button. The receiver
switches on, the LEDs light up.
If the correct channel is already set,
no further steps are necessary.
1s
To select a different channel:
ON/OFF
Press the channel selection button
repeatedly until the channel indi-
cator displays the desired channel
(see table).
If no further buttons are pressed,
4s
the channel indicator goes off after
Channel
30 seconds. If no channel is found,
the channel indicator flashes.
You hear the sound in
mono
mono
EKI 830
| 7
Advertisement
Table of Contents
