Electrolux Supreme 300L Instruction Manual page 5

Maximum shaft speed.
Danger of kickback. The blade is
capable of amputating arms and
legs.
Prior to use
• Do not use this machine for any other purpose
than that for which it was designed, using the
proper cutting devices as indicated in the
instructions.
• B1. Anyone who uses the machine should
have read the entire manual with extreme care.
• Make sure you know how to stop the engine
and blade if necessary (see section entitled
"Starting and stopping the engine").
• All users should be familiar with the operations
for use of the machine under absolutely safe
conditions as described in this manual, and
should be instructed in the proper cutting
techniques to use, possibly by practical
demonstration.
• Do not use the machine if you are tired, in poor
health or under the effects of alcohol or
medication that could affect your reactions.
• Do not allow children or persons who are not
familiar with these instructions and are not
sufficiently trained to use the brush cutter.
Local regulations may specify an age limit for
users.
• Keep this manual with the machine when
selling or lending it, to enable the future users
to familiarize themselves with the product and
instructions for safe use.
• Always inspect the machine carefully prior to
use: make sure it is correctly assembled and
that there are no loose screws, damaged parts,
fuel leaks.
• Replace any accessories (blades, nylon string
heads, guards) which show damage or cracks
or appear excessively worn. Have your
Authorized Service Center replace any
damaged parts.
• Perform all operations of maintenance and/or
assembly ONLY with the engine off and
wearing gloves.
Apparel
• B2. Dress suitably for the job; wear approved
personal protection gear: a) Close-fitting
clothing (no shorts or loose clothes). b) Safety
boots with non-slip sole, crush-resistant toe
cap and protection against cuts (do not wear
sandals or work barefoot). c) Sturdy gloves
2 - ENGLISH
CAUTION!
Danger of serious leg injuries.
Take scrupulous care to follow the
instructions in the manual.
CAUTION!
The cutting parts and muffler may
get very hot and cause burns. Wait
a few minutes before touching
them.
resistant to cuts and vibrations. d) Safety visor
or protective goggles. Remove the protective
film if any. e) Hearing protection. The use of
personal protection gear does not eliminate the
risk of injury but may reduce the effect of the
damage in case of accidents.
• Do not wear loose clothing or jewelry that could
get caught in the moving parts of the machine.
• Watch out for the rotating parts and hot
surfaces of the machine.
Health precautions
CAUTION! Avoid prolonged use.
Noise and vibrations may be
dangerous.
• Prolonged use of the machine or other
equipment expose the operator to vibrations
that can cause the White Finger Syndrome
(Syndrome of Raynaud). This could reduce the
sensitivity of the hands in distinguishing
different temperatures and cause a general
numbness. The operator should therefore
check the conditions of the hands and fingers if
the machine is used continuously or regularly.
If one of the symptoms should appear, consult
a doctor immediately.
• Prolonged use of the machine or other
equipment can cause discomfort, stress,
fatigue, hearing damage. Wear suitable
hearing protection when using the machine.
Correct and scrupulous maintenance can also
help to protect you further from the risk of noise
and vibration.
• Never start or run the engine in a closed or
poorly ventilated place.
CAUTION! The exhaust fumes are
toxic if inhaled, and may cause
asphixiation and even death.
Work zone
• Examine the work area and be careful of any
hazards (such as roads, driveways, power
lines, hanging tree limbs, etc.).
• Before use, remove any rubbish from the work
area such as rocks, broken glass, ropes, metal
parts, cans, bottles and any foreign body that
could become entangled with rotating parts or