Panasonic Touchbook CF-71 Series Reference Manual page 44

Dealing With Problems
Disk Operations
Cannot read/write to a
floppy disk
Unable to write to a
floppy disk
How to format a floppy
disk is unclear
Unable to read/write to
the hard disk
When the previous item
is not the cause
Trouble has occurred
with the CD
The computer does not
recognize the CD-ROM
pack
The access lamp (
does not light
Cannot play CD or read
data from it
Cannot eject CD
A b l u e b a c k g r o u n d
appears on the screen
with the MPEG image
T h e C D - R O M d r i v e
vibrates a lot
Has the floppy disk been correctly inserted?
Has the floppy disk been correctly formatted?
Has the Setup Utility been used to set [Floppy Operation] to [Enable]?
( page 34)
Your floppy disk content may be corrupted.
Is the floppy disk write-protected?
Select [Format] in [My Computer] - [3 1/2 Floppy (A:)] - [File]. After confirming the
disk volume and format type, start formatting.
Your drive or file may not have been properly set.
Check to see if the hard disk is full. If it is full, delete unnecessary files.
Your hard disk content may be corrupted. Contact Panasonic Technical Support.
Try testing another drive or media.
You may need to clean the lens or CD.
Did you restart the computer after installing the drivers?
Is the CD-ROM pack properly mounted in the multimedia pocket?
) Is the CD loaded on the tray correctly?
Is the CD bent, scratched, or dirty?
Is the computer powered on?
To remove a CD when the computer is powered off, insert a sharp object such as
the bent-out tip of a paper clip into the emergency hole. Pushing it completely to the
end will free the tray so that it can be pulled out.
Did you open the CD-ROM drive or remove the MPEG CD while it was operating?
Re-insert the MPEG CD and close the CD-ROM drive. Press Enter .
Is the CD bent labeled?
Emergency hole
44