Suspend/Hibernation Functions - Panasonic Touchbook CF-71 Series Reference Manual

Suspend/Hibernation Functions

Starting Up Your Computer Quickly
If you want to immediately start up and continue an application after shutting down
your computer, you can do so by using the suspend or hibernation function.
Differences between the suspend and hibernation functions
Function Suspend function
Where data is saved to Memory
Speed Fast
Requires power supply Yes
Setting the Suspend or Hibernation Function
[Hibernation] is factory set.
1
Run the Setup Utility
2
Using and
3
Using and
4
Using and
press Enter
5
Press F10 , then select [Yes]
Shutting Down Using the Suspend or Hibernation Function
The computer should be set for suspend or hibernation (
dure).
Press the sleep switch; at the "beep*" sound, release your finger.
(After releasing your finger from the
sleep switch, do not touch the sleep
switch or the power switch while the
computer is in the suspend or hiberna-
tion modes.)
CAUTION
At the "beep*" sound, release your finger from the sleep switch. If you con-
tinue to press down on the switch and hold it for more than four seconds, the
"beep*" sound will come out again and the power will go off. Data not previ-
ously saved will be lost.
Slide the power switch to power on. The power will not go on by pressing the
sleep switch.
Even when [Sleep Switch] is set to [No Action] with the Setup Utility, if the
sleep switch is pressed, a beep will sound and the power will go off if the
button is pressed for more than four seconds.
If the computer will not be operated for an extended period of time, it is recom-
mended that hibernation mode be used instead of the suspend mode.
*
When the speaker function is disabled, e.g., by setting [Disable] for [Speaker] with the
Setup Utility ( page
sound.
(if power is cut, all data is lost)
( page 31)
, select [Power]
, select [Sleep Switch] and press Enter
, select [Suspend] or [Hibernation] and
31) or by the key combination Fn + F4 , there will be no beep
Hibernation function
Hard disk
Somewhat slow
Power is not required to maintain data
see the above proce-
Suspend Mode
or
Hibernation Mode
4