Required Items; Before You Begin; Power Requirements - Eastwood Versa-Cut12740 Assembly And Operating Instructions Manual

REQUIRED ITEMS

Before you begin using the Eastwood Versa-Cut Model 12740 Plasma Cutting System make sure you have
the following:
• A clean, dry air supply source for the torch. An air compressor capable of delivering 5-7 CFM @ 85 PSI
is required. You can even use a portable air tank with regulator. The air supply must be dry and the
use of a moisture trap is strongly recommended.
• A properly grounded 110-120 VAC 50/60 Hz. on a 15 Amp Circuit or a 220-240 VAC 50/60 Hz. on
a 30 Amp circuit.
NOTE: Unit must be grounded to work properly and safely!
• A clean, safe, well-lit, dry and well-ventilated work area.
• A non-fl ammable, long sleeve shirt or jacket.
• Heavy Duty Welding Gloves (Eastwood #12590 or equivalent)
• Auto Darkening Welding Mask (Eastwood #12099 or equivalent) to provide eye protection during
cutting operations.

POWER REQUIREMENTS

The Eastwood Model 12740 Plasma Cutting System is voltage sensing; it will automatically operate on
110-120 VAC, 50/60hz., 15 Amps or 220-240 VAC, 60/50 hz., 30 Amps.

BEFORE YOU BEGIN

Remove all items from the box. Compare with list below to make sure unit is complete.
CONTENTS:
• Model 12740 High-Frequency Plasma Cutter with Inverter Technology.
• Torch and 20' Supply Line.
• 1' NEMA 50 240 Volt to 110 Volt grounded adapter cord.
• 10' Ground Lead and clamp.
• Instruction Booklet.
4 © Copyright 2011 Easthill Group, Inc.