Required Items; Power Requirements; Before You Begin - Eastwood VERSA-CUT 60 Assembly & Operating Instructions

REquIRED ITEMS

Before you begin using the Eastwood Versa-Cut 60 Plasma Cutter make sure you have the following:
• A clean, dry air supply source for the torch. An air compressor capable of delivering 5-7 CFM @ 60 PSI is required.
You can even use a portable air tank with regulator. The air supply must be dry and the use of a moisture trap
is strongly recommended.
• Eastwood recommends at a minimum a properly grounded 220-240 VAC 50/60Hz., 50 Amp circuit.
NOTE: Unit must be grounded to work properly and safely!
• A clean, safe, well-lit, dry, and well-ventilated work area.
• A non-flammable, long sleeve shirt or jacket.
• Heavy-Duty Welding Gloves (Eastwood #12590 or equivalent)
• Plasma Cutting Glasses (Eastwood #13948) or Welding Helmet (Eastwood #13203 or 13212) to provide eye
protection during cutting operations.

POWER REquIREMENTS

The Eastwood Versa-Cut Plasma Cutter is supplied with the popular NEMA 6-50P plug, requiring a NEMA 6-50R recepticle.

BEFORE YOu BEGIN

Remove all items from the box. Compare with list below to make sure unit is complete.
• Versa-Cut 60 Plasma Cutter
• Torch and 20' Supply Line
• 10' Ground Lead and clamp
• Instruction Booklet
• Face Shield
• Extra Electrode and Nozzle
4
Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com