Replacement Of Lamp Bulbs; Bulb Capacity - Mitsubishi Lancer Owner's Manual

Replacement of lamp bulbs

E01003100215
Before replacing a bulb, ensure the lamp is off. Do
not touch the glass part of the new bulb with your
bare fingers; the skin oil left on the glass will evap-
orate when the bulb gets hot and the vapour will
condense on the reflector and dim the surface.
CAUTION
l Bulbs are extremely hot immediately af-
ter being turned off.
When replacing a bulb, wait for it to cool
sufficiently before touching it. You could
otherwise be burnt.
NOTE
l If you are unsure of how to carry out the
work as required, we recommend you to con-
sult a specialist.
l
Be careful not to scratch the vehicle body
when removing a lamp or lens.
l When it rains or when the vehicle has been
washed, the inside of the lens sometimes be-
comes foggy. This is the same phenomenon
as when window glass mists up on a humid
day, and does not indicate a functional prob-
lem. When the lamp is switched on, the heat
will remove the fog. However, if water gath-
ers inside the lamp, we recommend you to
have the lamp checked.

Bulb capacity

E01003200173
When replacing a bulb, use a new bulb with the
same wattage and colour.
Outside
E01003302178
Front
Except for vehicles with high intensity discharge
headlamps
1. Front turn-signal lamps: 21 W (WY21W)
2. Headlamps, high-beam: 60 W (HB3)
3. Headlamps, low beam: 51 W (HB4)
4. Front fog lamps*
1
: 55 W (H11)
5. Position lamps: 5 W (W5W)
6. Side turn-signal lamps* 2
: 5 W
Vehicles with high intensity discharge headlamps
1. Front turn-signal lamps: 21 W (WY21W)
2. Bending lamps (Adaptive Front lighting Sys-
tem (AFS)): 55 W (H11)
3. Headlamps, high/low beam (Discharge
2
bulb)* : 35 W
4. Front fog lamps* 1
: 55 W (H11)
5. Position lamps: 5 W (W5W)
6. Side turn-signal lamps* 2
: 5 W
*1: if so equipped
*2: Have the lamps bulbs replaced at a
MITSUBISHI MOTORS Authorized
Service Point.
OG1E12E1
Maintenance
Codes in parentheses indicate bulb types.
WARNING
l Check with a MITSUBISHI MOTORS
Authorized Service Point when it is neces-
sary to repair a high intensity discharge
headlamp or to replace the bulb. The pow-
er circuit, bulb and electrodes generate
high voltages that may cause a severe
shock.
NOTE
l For the side turn-signal lamp, it is not possi-
ble to repair or replace just the bulb.
Check with a MITSUBISHI MOTORS Au-
thorized Service Point when the lamp needs
to be repaired or replaced.
Rear
7. Rear fog lamp (LHD vehicles): 21 W
(W21W)
Reversing lamp (RHD vehicles): 21 W
(W21W)
8. High-mounted stop lamp
9. Licence plate lamps: 5 W (W5W)
8
8-27