Sony RCD-W222ES Service Manual page 43

4-5. CD-RW Recording Adjustment and Self Record/Playback Check
1) Select the menu as follows. Control → Macro, and select 05cdrw_S.ttl.
Press "Open".
2) Place the test CD disc PATD-012 on the Deck A. Place the
recording CD-RW disc (See Note: 4-5-1) on the tray (Deck
B) as prompted by the display and press "OK". (See Fig. 4-
46)
Note : 4-5-1
The disc to be used in this step.
* Use the CD-RW disc CWM74 for audio, that is manufactured
by Sony.
* The disc that is used by this step cannot be used for the general
purposes and for the purpose of operation check of the RCD
series equipment as it is. The disc that is used for the general
purposes or for the purpose of operation check of the RCD
series equipment, cannot be used in this step.
When you want to use the CD-RW disc for other applications,
erase the CD-RW disc.
* If the recording is interrupted by any reasons during the
recording operation (i.e., the WRITE POWER ON LED of the
jig is lighting), the disc cannot be used any more in the
subsequent step. In such a case, erase the CD-RW disc and
repeat this step from the very beginning again.
3) When the disc that is used in step 2) is the disc that has been
used in the electrical adjustment in the past. ....... Press "Yes".
When the disc that is used in step 2) is a completely blank disc.
......... Press "No". (See Fig. 4-47)
Note : The recording CD-RW disc can be used only for the
electrical adjustment. The recording CD-RW disc must
be controlled so that it must not be used for any other
applications.
4) Press the H button of Deck A. After playback starts, press
"OK". (See Fig. 4-48)
5) When the message as shown in Fig. 4-49 appears some seconds
later, select 4x of the test mode (refer to page 18, Play Speed
Selection Mode (Deck A)) PLAYBACK SPEED. Then press
the H button of Deck A. After playback starts, press "OK".
4 Fig. 4-46
4 Fig. 4-47
4 Fig. 4-48
4 Fig. 4-49
RCD-W222ES
43