Table of Contents
Advertisement
Adjusting surface fit
Manually correct geographic distortion by Surface Fit calibration function.
1.
Press MENU/EXIT and then press
2.
Press
correction page displays.
3.
Press
4.
Select the direction you want to adjust and press MODE/ENTER.
5.
Press
adjustment is for distortion only.
6.
For both sides of the horizontal surface fit, use
curve because it is not always at the center.
To continue with the vertical surface fit adjustment,
1.
Press MENU/EXIT to go back to the surface fit page.
2.
Press
3.
Select the direction you want to adjust and press MODE/ENTER.
4.
Press
adjustment is for distortion only.
5.
For both sides of the vertical surface fit, use
because it is not always at the center.
24
Operation
to highlight Surface Fit and press MODE/ENTER. The Surface Fit
/
to select Horizontal and press MODE/ENTER.
/
to adjust the left or/and right side convex or concave. Single side
/
to select Vertical and press MODE/ENTER.
/
to adjust the top or/and bottom side convex or concave. Single side
/
until the DISPLAY menu is highlighted.
/
to adjust the center of the
/
to adjust the center of the curve
Advertisement
Table of Contents
