How To Create A New User Pin - iStorage datAshur User Manual

User PIN requirements:
• Must be between 7-15 digits in length
• Must not contain only repetitive numbers, e.g. (3-3-3-3-3-3-3)
• Must not contain only consecutive numbers, e.g. (1-2-3-4-5-6-7), (7-8-9-0-1-2-3-4), (7-6-5-4-3-2-1)
• datAshur must NOT be connected to a host
INSTRUCTIONS
Press KEY Button
Enter User PIN to unlock drive
(Factory default PIN 1,1,2,2,3,3,4,4)
and press KEY Button
Press and hold KEY Button
illuminated enter New User PIN
While
and press KEY Button
Re-enter New User PIN
and press KEY Button
Insert datAshur into USB port
Note:
If a mistake was made while defining a new PIN or the procedure was not completed, the drive will retain
the old PIN.

4. How to create a new User PIN

When all cryptographic parameters have been zeroed.
All cryptographic parameters (including User PIN and Admin PIN) are zeroed:
•
After hacking detection has been triggered by 10 consecutive failed attempts to unlock,
•
When the datAshur has been manually reset (see section 11 "How to Reset the datAshur").
This state is evident by a solid lit
instructions.
When either of the above two scenarios occur, it will be necessary to set a new User PIN by following the instructions
below.
#6
for 3 seconds
RED LED indicator. It will be necessary to set a New User PIN by following these
www.istorage-uk.com
LED ACTIVITY
will blink together
will illuminate together for approximately
4 seconds and then:
will blink indicating correct PIN entry
will illuminate together
will blink in unison
will illuminate and then
change to blinking change to blinking
N.B.
blinks if 1 and 2
st
blink alternately if PIN entry incorrect
entries match
nd