Table of Contents
Advertisement
SECTION 4
GJ'IB
Interface
Model
3933A Phase Shifter
Sweep Parameter
Setting
Messages
(Cont.)
'unction
WEEI SINGLE START
'INGL START BNC
:NABLE
Enables/disables
rear panel SINGL START
IN BNC connector when unit is in remote.
(SGEl: when SINGL START IN is enabled,
and START signal is received, a single
sweep is performed. In local this connector
is always enabled. When unit is placed in
remote, status of SINGL START IN rehnns
Disables SINGL START IN
while unit is in remote.
Enables SINGL START IX
while unit is in remote.
;WEEP START STATE
iWEEP STOP STATE
iOLD IN BNC ENABLE
sweep not in HOLD, the command is ig-
nored and no error occurs.)
HOLD IN assumes the previous remote
status. Initial status at power up or when
the PST code has been executed is HLE 1.1
Disables HOLD IN when unit
is in remote.
Enables HOLD IN when unit
is in remote.
NOTE: men
HOLD IN is enabled (HLE I), the relationship
between the HOLD IN connector and the HLD and RSM codes is as f0110ws:
1. When a HOLD signal is applied to HOLD IN (set low), the HLD and RSM codes have no effect on the sweep. The weep
restarts when
HOLD is removed from the HOLD W connector (set high).
2.
When a sweep has been halted by the HLD code, the HOLD IN connector is disabled. The sweep resumes when a EM
command is
issued.
4-29
Advertisement
Table of Contents
