Table of Contents
Advertisement
SECTION 1
General In,formation
1.6.4
Repacking
For Shipment
Should it become necessary to return the Model 3930A
for repair, carefully
pack the unit in its original
packing
carton or the equivalent.
Be sure to use a cardboard box of
sufficient
strength if the original carton is not used.
Include the following
information:
l
Advise as to the warranty
status of the instrument.
l
Write ATTENTION
REPAIR DEPARTMENT
on the
shipping
label.
l
Filloutandincludetheserviceformlocatedattheback
of this manual.
1.7
OPTIONAL
ACCESSORIES
The following
accessories are available for use with the
Model 3930A.
Models
3900-l and 3900-Z Rack Mounting
Kits: The
Model 3900-l mounts one Model 393OA in a standard 19
inch rack. The Model 3900-2 mounts two Model 3930As
side by side in a standard 19 inch rack. Both kits include
all necessary hardware
for proper rack mounting
of the
instruments.
Model
7007 Shielded
IEEE-488
Cables: The Model
7007-l Urn, 3.3ft.j and Model 7007-Z (2m, 6.6ft.) can be
used to interface the Model 3930A to the IEEE488 bus.
Model 7051-Z BNC-to-BNC
Cable: The Model 7051-Z is
SOL2 BNC to BNC cable (RG-580
2ft. (0.6m) in length.
The Model 7051-2 is terminated
with male BNC connec-
tors on both ends.
Model 7051-5 BNC-to-BNC
Cable: The Model 7051-Z is
5OQ BNC to BNC cable (RG-58C) 5ft (1.2m) in length.
The Model 7051-5 is terminated
with male BNC connec-
tors on both ends.
Model7051-lOBNC-toBNCCable:TheModel7051-10is
similar to the Models 7051-2 and 7051-5 except that it is
loft. in length.
Model
7754-3 BNC-to-Alligator
Cable:
The Model
7754-3 is a 3ft. (O.Vm) 500 cable (RG-580,
terminated
with a male BNC connector on one end and two alligator
clips on the other end.
Model 7755 5OQ Feed-through
Terminator:
The Model
7755 is a BNC to BNC adapter that is terminated
with a
5OQ resistor. VSWR is ~1.1, DC to 250MHz.
1.8
SPECIFICATIONS
Detailed Model 3930A specifications
may be found in
Appendix
B.
l-3
Advertisement
Table of Contents
