Radio Shack 43-3818 Owner's Manual page 37

2.4ghz cordless phone with caller id and digital answering system
Table of Contents

Advertisement

2TQDNGO
The phone cannot be
operated at a useful
distance from the base
because the signal
becomes weak or noisy.
The handset battery
pack does not charge.
The handset does not
ring or receive a page.
You have an incoming
call, but do not receive
any Caller ID
information.
The handset stops
working or works poorly
during a call.
The system does not
answer calls.
The system does not
record the caller's
messages
Lift the base's antenna to a vertical position.
The handset's range has decreased. Return the handset to the
cradle and recharge the battery pack. Replace the battery
pack if necessary.
If the charging contacts on the handset and base are dirty,
clean them with a pencil eraser.
Be sure the battery pack is connected correctly.
Replace the battery pack.
Move the base away from other electrical devices and sources
of noise.
Move the handset closer to the base.
Lift the base's antenna to a vertical position.
Be sure the battery pack is charged. (If the battery power is too
low, it does not have enough power to light the display.)
Let the phone ring twice before you answer, so the system has
time to record the Caller ID information.
Check that the system is correctly and securely connected.
Verify with the phone company that your CID service is active.
Move the handset closer to the base.
Lift the base's antenna to a vertical position.
Be sure the battery pack is charged. (If the battery power is too
low, it does not have enough power to light the display.)
If the base loses power while the handset is away, the security
access-protection code might change. Restore power to the
base, then place the handset back on the base. The
CHARGE/IN USE indicator lights, indicating that the code is
set again.
If the charging contacts on the handset and base are dirty,
clean them with a pencil eraser.
Make sure the system is turned on and the AC adapter is
properly connected.
Check all phone line connections.
Recording time is set to announce only. Set it to
Delete messages if the memory is full.
5WIIGUVKQP
' ' ' '
* * * *
or
.
37

Advertisement

Table of Contents
loading

Table of Contents