To Install The Heat Sink; To Remove The Processor - ReliOn R1700 User Manual

2.4.2 To install the heat sink

Reverse the steps above to install the heat sink. When installing the heat sink, make sure to
position it in the direction where the ends of the heat sink fins face the front and back of the
chassis, as shown in the picture below, to allow proper airflow:
Before you put the heat sink on top of the installed processor, please do not forget to
check if the grease is complete on bottom of the heat sink.

To remove the processor

2.4.3
Unlock the load lever and lift it up.
Open the load plate.
1230B0059901
Figure 2-7 Positioning the Heat Sink to Allow Airflow
Figure 2-8 Opening the Load Plate
Hardware Operations
2-7