Table Ii European Union Emc Requirements - ReliOn R1700 User Manual

Table of Contents

Advertisement

installed in a residential environment (for example, personal computers). The FCC requires
devices in both classes to bear a label indicating the interference potential of the device as well as
additional operating instructions for the user.
The rating label on the device shows which class (A or B) the equipment falls into. Class A devices
do not have an FCC logo or FCC ID on the label. Class B devices have an FCC logo or FCC ID on
the label. Once the class of the device is determined, refer to the following corresponding
statement.
Class A Equipment
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference, in which
case the user will be required to correct the interference at personal expense.
Declaration of Conformity for Products Marked with the FCC Logo—United States Only
This device complies with Part 15 of the FCC Rules Operation and is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
For questions regarding your product, please contact the supplier.
To identify this product, refer to the Part, Series, or Model number found on the product.
European Union Notice
Products with the CE Marking comply with both the EMC Directive (89/336/EEC) and the
Low-Voltage Directive (73/23/EEC) issued by the Commission of the European Community.
Compliance with these directives implies conformity to the following European Norms (in brackets
are the equivalent international standards):
EN55022 (CISPR 22)
EN55024 (IEC61000-4-2,3,4,5,6,8,11)
EN61000-3-2 (IEC61000-3-2)
EN61000-3-3 (IEC61000-3-3)
1230B0059901

Table ii European Union EMC Requirements

Electromagnetic Interference
Electromagnetic Immunity
Power Line Harmonics
Power Line Flicker
About This Manual
vii

Advertisement

Table of Contents
loading

Table of Contents