To Remove The Heat Sink; Figure 2-6 Removing The Heat Sink - ReliOn R1700 User Manual

Reminder
Before you remove or install the heat sink or processor, please follow the steps below:
Step 1: Make sure the server is not turned on or connected to the AC power. To power off
the server, see "2.1.1 Power Off" in the System User Manual.
Step 2: Remove the chassis cover. To remove the cover, see "2.2 Chassis Cover" in the
System User Manual.

2.4.1 To remove the heat sink

Release the four screws.
Lift the heat sink up from the installed processor.
1230B0059901

Figure 2-6 Removing the Heat Sink

Hardware Operations
2-6