GMC 2016 Yukon User Manual page 233

232 Driving and Operating
(On/Off) : Press to turn the
system on or off. A white indicator
comes on in the instrument cluster
when cruise is turned on.
SET (Set/Coast) : Press briefly to
set the speed and activate cruise
control. If cruise control is already
active, use to decrease vehicle
speed.
+RES (Resume/Accelerate) : If
there is a set speed in memory,
press to resume that speed or press
and hold to accelerate. If cruise
control is already active, use to
increase vehicle speed.
(Cancel) : Press to disengage
cruise control without erasing the
set speed from memory.
Setting Cruise Control
If is on when not in use, SET or
+RES control could get pressed and
go into cruise when not desired.
Keep the cruise button off when
cruise is not being used.
1. Press to turn the cruise
system on.
2. Get up to the desired speed.
3. Press and release SET . The
desired set speed briefly
appears in the instrument
cluster.
4. Remove foot from the
accelerator.
The cruise control indicator on the
instrument cluster turns green after
cruise control has been set to the
desired speed. See Instrument
Cluster 0 131.
Resuming a Set Speed
If the cruise control is set at a
desired speed and then the brakes
or is applied, the cruise control is
disengaged without erasing the set
speed from memory.
Once the vehicle speed reaches
about 40 km/h (25 mph) or more,
briefly press +RES. The vehicle
returns to the previous set speed.
Increasing Speed While Using
Cruise Control
If the cruise control system is
already activated:
Press and hold the +RES button
until the vehicle accelerates to
the desired speed, then
release it.
To increase vehicle speed in
small increments, briefly press
+RES. For each press, the
vehicle goes about 1.6 km/h
(1 mph) faster.
The speedometer reading can be
displayed in either English or metric
units. See Instrument Cluster 0 131.
The increment value used depends
on the units displayed.
Reducing Speed While Using
Cruise Control
If the cruise control system is
already activated:
Press and hold the SET button
until the desired lower speed is
reached, then release it.