Changhong Electric LED40D1100ISX Operation Manual page 17

Basic Operation
Turning on and off the TV
■ Turn on the TV
Connect the power cable, if TV has a power switch, turn it on firstly. Press the
button on remote control can turn on TV from standby mode.
■ Turn off the TV
Press the button on the remote control to enter standby mode.
Do not leave your set in standby mode for long periods of time. It is best to unplug the
set from the mains and aerial.
When there is an accident power off, it is recommended to unplug the power cable
from the power socket.
■ No signal
There is No Signal menu on screen when there is no input signal. In DTV/ATV mode,
if there is no signal in 5 minutes, the TV will turn off automatically. In PC-RGB
mode, the TV set will automatically turn off in 1 minute if no input signals. When VGA
cable is connected, the TV turns on automatically.
Programme Selection
■ Using the CH+/CH- on the panel of TV or ∧P∨ on the remote control.
Press CH+/∧ to increase channel number.
Press CH-/ ∨ to decrease channel number.
■ Using 0- 9 Digital Buttons.
You can select the channel number by pressing 0 to 9. (In DTV, ATV mode)
■ Example
To select - channel (e.g. Channel 5): Press 5.
To select -- channel (e.g. Channel 20): Press 2 and 0 in a short time.
Volume Adjustment
■ Press the VOL+/VOL- on the panel of TV or +
volume.
■ If you want to switch the sound OFF, press the
■ You can release mute by pressing the
Changing the Input Source
1. You can select the input source by pressing the HOME/SOURCE button to open
Smart Home interface.
2. Press the ▲/▼ button to cycle through the input source, and press the OK button to
confirm your choice.
- on the remote control to adjust the
.
or increase the volume.
14