Riving Knife Adjustment - Makita 5704R Instruction Manual

For straight cuts, align the A position on the front of the
base with your cutting line. For 45° bevel cuts, align the B
position with it.

Riving knife adjustment

1
2
1
3
1 - 5mm
005410
Use the hex wrench to loosen the hex socket head bolt
for the riving knife adjustment, then raise the lower blade
guard. Move the riving knife up or down over the two
protuberances for settings indicated in the figure, so as to
obtain the proper clearance between the riving knife and
saw blade.
CAUTION:
Ensure that the riving knife is adjusted such that:
•
The distance between the riving knife and the
toothed rim of the saw blade is not more than 5 mm.
The toothed rim does not extend more than 5 mm
beyond the lower edge of the riving knife.
Switch action
1
005411
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and returns
to the "OFF" position when released.
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided. To start the tool,
push in the lock-off button and pull the switch trigger.
Release the switch trigger to stop.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
1. Setting
protuberances
2. Hex socket head
bolt (For
adjusting riving
knife)
3. Cutting depth
1. Switch trigger
2
2. Lock-off button
Removing or installing saw blade
The following blade can be used with this tool.
Max. dia. Min. dia. Hole dia.
190 mm 170 mm 20 mm or 30 mm
006483
The thickness of the riving knife is 1.8 mm.
CAUTION:
Do not use saw blades which do not comply with
•
the characteristics specified in these instructions.
Do not use saw blades the disc of which is thicker
•
or the set of which is smaller than the thickness of
the riving knife.
1
005412
CAUTION:
Be sure the blade is installed with teeth pointing up
•
at the front of the tool.
Use only the Makita wrench to install or remove the
•
blade.
To remove the blade, press the shaft lock fully so that the
blade cannot revolve and use the wrench to loosen the
hex bolt counterclockwise. Then remove the hex bolt,
outer flange and blade.
To install the blade, follow the removal procedure in
reverse. BE SURE TO TIGHTEN THE HEX BOLT
CLOCKWISE SECURELY.
3
2
1
005413
When changing blade, make sure to also clean upper
and lower blade guards of accumulated sawdust. Such
efforts do not, however, replace the need to check lower
guard operation before each use.
8
Blade thickness Kerf
less than 1.7 mm more than 1.9 mm
1. Hex wrench
2
2. Shaft lock
1. Hex socket
head bolt
2. Outer flange
3. Saw blade
4. Inner flange
4