Replacing The Hard Disk Drive - Lenovo ThinkCentre 0900 User Manual

1. Install the solid-state drive into the storage converter. Then, install the 4 screws to secure the solid-state
drive to the storage converter.
Figure 21. Installing the solid-state drive into the storage converter
2. Connect the signal cable and the power cable to the solid-state drive.
3. Install the solid-state drive into the hard disk drive bay. See "Replacing the hard disk drive" on page 43.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 73.

Replacing the hard disk drive

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page v.
This section provides instructions on how to replace the hard disk drive.
Note: Depending on your model type, your computer might come with a 2.5-inch solid-state drive. To install
the solid-state drive, see "Installing the solid-state drive" on page 42.
To replace the hard disk drive, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 34.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 34.
.
Chapter 5 Installing or replacing hardware
43