Splitting Logs - King Canada KCG-15LS Instruction Manual

STARTING YOUR ENGINE
To safely start your engine, follow these steps (Fig.19).
Note: No choke is required on warm engines. Pull the recoil starter handle until resistance is felt, then pull it out with a rapid full arm stroke. Let
the starter rope rewind slowly, repeat if necessary. Allow engine to run at no load for 5 minutes upon each initial start-up to allow engine to
stabilize.
STOPPING YOUR ENGINE
1) Move the throttle lever (step 9, Fig.19) towards the right.
2) Turn the engine switch (step 6, Fig.19) to the "OFF" position
(upwards).
3) Close the fuel shut-off valve (step 3, Fig.19) by moving it
towards the left.
LOADING LOGS (Fig.20)
Load log onto beam with a cut end against the endplate –
positioned for a lengthwise cut.
Notes:
a) The log splitter is designed only for cutting lengthwise with the grain, NOT for
cutting across the grain.
b) This log splitter is designed for cutting logs only up to a maximum of 16" in
diameter and 21" long. Larger diameter logs could get stuck on the wedge and
longer logs will not fit on the beam.
WARNING: ALWAYS keep hands and feet away from the endplate, wedge, and
partially split logs while loading, operating and unloading the log splitter.
Important safety instruction: Vertical position loading: Place the log on the
endplate and turn it until it leans against the beam and is stable. If the log is too
big or oddly shaped, stabilize the log with wooden shims between the log and
endplate or ground. DO NOT use your leg or knee to stabilize the log. NEVER
stabilize the log by placing your hand on top of the log.
Splitting Operation
1) Move split control lever (A) Fig.21 toward endplate to extend wedge and split
log.
2) Release split control lever to stop wedge movement when log is split.
WARNING: Cracks in logs can close quickly and pinch fingers. Keep fingers away
from any cracks that open in partially split logs.
STARTING ENGINE, LOADING
& SPLITTING LOGS
Figure 19
Figure 20
Figure 21
Figure 22