Phoneaccess™ User's Guide - Security Command XR20 Executive Series User Manual

Typical Arming/Disarming Display Description
20002 ARMED 0016 01 EAST WAREHOUSE
Account Event User # Area # Area Name
Events - ARMED or DISARMED
User Checkin Display Description
20002 USER CHECKIN REPORT BY 0016
Account Function Performed User #
Functions - USER CHECKIN REPORT (An authorized user has selected Checkin from the User Menu)
Typical System Event Display Description
20002 LATE TO CLOSE
Account Event
Events - LATE TO CLOSE (The system has not been armed at its scheduled closing time)
ALARM CANCELLED (An alarm has been cancelled by an authorized user)
PhoneAccess™ User's Guide
For your reference a PhoneAccess™ pocket guide is provided on the
last page of this User's Guide.
This exciting feature allows you to call your XR20 system from any
outside touch-tone phone to arm and disarm protection areas or
turn panel relay outputs on or off. Faulted zones force arm when
the area arms.
How it works
1. From a touch tone phone, call the system phone number.
The XR20 answers and sounds a short ready tone.
2. You now have eight seconds to enter a valid Master user
code. If the panel accepts the user code, you hear one or
more beeps indicating the system current armed status.
Appendix
The following table identifies the beeps and what they
represent.
If
All areas are armed
Area 1 (Perimeter) is armed
Any area is armed
All areas are disarmed
Note: You can also find out the system armed status by pressing
the * key at any time.
3. If the user code is not accepted by the panel, you hear four
short beeps. Check the user code and try again. After three
unsuccessful attempts to enter the code, the panel locks
out PhoneAccess™ until a valid user code is entered at a
keypad.
4. Once the user code is accepted by the panel and the
armed status is given, you can enter arming and disarming
commands.
Press For this action
# then 1 Arm all
# then 2 Arm Perimeter
# then 3 Arm Perimeter/Interior
# then 0 Disarm all areas
#, 5, 4, 0, n* Toggles the output
*
Use outputs 1, 2, 3 or 4 in place of n. Enter output descriptions below.
1. ________________________ 3. _________________________
2. ________________________ 4. _________________________
XR20 User's Guide
You will hear
3 short beeps
1 short beep
2 short beeps
1 long beep
You will hear
3 short beeps Note: Zones
1 short beep
in a faulted
2 short beeps
condition
1 long beep
are force
1 short beep = on
armed
1 long beep = off
when the
4 short beeps = restricted
area arms.
37