Panasonic GP-MH310 series Technical Manual page 42

Notice on product operations
◆ Please limit under recommended power supply value, and please consider power protection equipment to
be installed to the product.
◆ When incorporate this product into your products, please use mounting hole that is shown in this document.
Also, according to this document, please use screws that size are proper in each circumstance.
◆ Please use recommended connecter that is shown in this document.
◆ When incorporate this product into your products, please check the connecter is inserted in right position,
do not insert with obliquity.
Otherwise, smoke or burnout could be occurred from the circuit or material inside the product. Also, please
do not pinch the cable between this product and the case of your product
◆ When you remove or insert cable from product's connecter, please consider not to be added strong
external forces to the connector of this product. External forces may cause PCB damage or internal
connection's problem
◆ When you power on the product to test or check, you must control switch on and off correctly. While the
power on, do not remove or insert product's connecter because it would cause of the damage.
◆ When incorporate this product into your products, please consider to prevent the static electricity during the
operation. The internal material would be destroyed by the static electricity. Handling is done on the floor
that conductive mat and workers need to wear earth band to make sure the product is free of the static
electricity.
◆ Please do not showers any gas to the product or use it in abnormal atmosphere. It may result failure of the
product.
◆ Please do not drop or give any mechanical shock or impact. It may result failure of the product.
.
−32−
.