Notes - Panasonic GP-MH310 series Technical Manual

Communications Protocol

[5] Notes

Note 1 Area Settings
Divide the screen into 256 areas(16 vertical,16 horizontal). Masking area is "1" and no-masking area is "0".
Within the each horizontal line, assign 0 or 1. The right end will become upper bit and left end will become lower bit.
One command will set up one horizontal line. Therefore, to set the area on the full screen, lines 0-15 shall be set.
Example: Motion Mask Area Settings (Figure 1)
When setting Figure 1 (the area covered in black shows the position of the mask), transmit in the order described
below.
To set up the mask in line 5 for example.
A0 HEADER
08 MOTION COMMAND
13 MOTION AREA
SETTING
01 Aspect Set
(0[16:9] 1 [4:3] )
05 ASSING THE LINE
NUMBER
03 Line 5
0C
（0011110001111111
07
→0011,1100,0111,1111）
0F
CS CHECK SUM
FF TERMINATOR
Above commands should be sent in order. Repeat the same procedure for other lines, if necessary.
* Same procedure for: ATW mask Area, Motion Detector Mask, Mask BLC Area.
* Same procedure for: Status 8(Motion Detected Area / Auto Pursuit Detected Area) and Status 10(Face Detected
Area) in Query Commands. It returns the value without "Aspect Set" as above.
(The area where motion is detected will be "1".)
−16−
Model: GP-HB310