Panasonic GP-MH310 series Technical Manual page 33

Function Descriptions
<General Explanation about Custom Preset Function>
The user can set their own default setting, and the settings can be maintained even after power off/on or All Initial.
<Command>
- C.PRESET COMMAND
→ All settings memorized at C.MEMORY will be changed back to the Custom Preset Default value.
It will not effect the current camera settings.
- C.MEMORY COMMAND
→ Current camera settings will be memorized.
Memorize will be available to the Custom Preset setup available items
- C.RECALL COMMAND
→ Change the camera settings to the settings memorized with C.MEMORY
The changed settings will be maintained after power off/on.
<How to use>
1) Send C.RESET
2) Send C.RECALL
(Camera settings will be changed to the "Custom Preset Default value")
3) Change other settings to the default value by command, if any.
4) Send C.MEMORY command to memorize the camera setting as default.
* After complete above process, user can set back the camera settings to the default value memorized with the
above step 4) by sending "C.RECALL" command.
<NOTE>
* Below items are changed from the original default value to the custom preset default value.
- SENSE UP
- BLC ON
- Near Limiter
- D<-->N switching time
* Settings set with Custom Preset will not be deleted after ALL INITIAL.
To delete, send C.RESET.
A0 01 14 00
A0 01 14 01
A0 01 14 02
OFF → X32
BLC MULTI → BLC CENTER
1m → 3m
10sec → 5sec
−32−